My K20a2 EG build up thread - TONS of pics!

[EJ_Allmota]

damn man, you are doing the damn thing..

[Fuster_Cluck]

Session 019:

time!!

Removing the gas and brake pedal assembly.

Everything you remove to get the assembly out of the vehicle is 12mm. This is assuming you have the brake booster and clutch slave cylinder removed already.



Remove the 12mm nut:



Closer look at the nut:



Disconect the throttle cable, but how??



Ahhhhh, just pinch the 2 clips and it pops out:



Cotter pin that will need to be removed once the assembly is out:
(Good luck removing it while the assembly is still mounted)



Remove that 12mm bolt and the assembly is ready to come out:
(LAMFExtFTW)



One of the harness you'll need to disconnect:



Assembly out:



Time to work on the clutch assembly:



Remove the bolt using your LAMFExt:



2 harnesses / 12mm bolt to remove:



and the assembly comes out once you disconnect the 2 harnesses:



Gas pedal:



Bump stop on the gas pedal. Pic so I can reinstall it close to the original setting:



Throttle cable clip ($hit's nasty):



Pull it outward with some pliers:



Pry the rubber protectors out with a flathead screwdriver:



2 switches that engage and disengage the clutch?? First time seeing this stuff so I
really don't know. Plus I'm a noob to the technical side of cars :P



The assembly cleaned up, ready to be prepped for paint:



Speaker wire I need to replace:



Thanks for the props again guys.