Session 4:

Today I only had a few hours since I went over to a friends house to help move some sheets of wood to his attic from garage. I did manage to tuck the hatch wires, remove the dome light, and took a look at relocating the fuse box.

Here's what I started with today:





Panel tool really helped out with a lot of the clips:



Handy little mirror allowed me to easily squueze the rear of the clips with angled pliers for an easy removal:



These 2 wires were just tucked in the hole :hammer: Any idea what they were for??



I ended up cutting that part of the harness since I don't need the 3rd brake light or defroster:



This is what was removed when I made the cut above:



There was no need to cut the driver side defroster harness, so I tucked it back out of the way:



For the gas/trunk lever located inside the door sill remove the (2) 10mm bolts:



With pliers just grab the wire and rotate downward toward the little gap. The wire will just come out:



And the completed rear interior tuck:





I removed the dome light harness.

This is where the dome light wires lead to.
Disconnect and the dome light harness is good to go for reinstall:



Had a little bit of time left, so I took a close look at relocating the fuse box under the dash.

My first time seeing the back side of a fuse box:



How do I get that under here?? Need some pointers with this one
I'm thinking first unwrap all the wiring under the battery area.