i have a mono amp that is good down to 1 ohm
i have a dvc 4 ohm 15 inch speaker
on the amp there is 2 sets of speaker inputs, 2+'s 2-'s
1.now can i hook up each VC to its own speaker inputs, and if so is the sub now running at 2 ohms
2a. or do i need to splice both +'s and both -'s before the speaker input and then use only 1 of the sets of speaker inputs
2b. if i need to use the second setup should i bridge it, for sum reason i remember sumthing about a mono amp works the same bridged or not
any help would be great, im getting ready to rip all my audio out again and wanna get wiring diagrams done before i start the build