My 3 Rotor Project..

[Herblenny]

During this build, I had a chance to go visit Chris Ludwig from Ludwig Motorsport to check on the harness for the engine.

We decided to use the AEM coils with the Haltech PS2K.



Mil-spec connector..

[Herblenny]

Here is something new for the 20B that I'm debuting..



ITs the new Xcessive Engineering lower intake manifold for the 20B. This is made for those interested in doing 3 rotor swap on RX7s, by lowering the height of the manifold and also each runner has an individual injector port. By using this, I'll be running 6x ID2000s on this manifold and 3x ID1000s on primaries on the irons. This much fuel, I'll be good for E85, 1000+WHP.... but shooting for 700-800 ish WHP.



I also studded the LIM and cut various FD hardwares to get this studded look with chrome hardwares. Also, better view of the LIM with UIM.

[Herblenny]

My off time past week, I was fabricating a blank cluster surround so I can retro fit my Defi cluster.



about 50% done and going to make a mold once its smoothed out, primered, painted, and then make it in CF.

Also, AC panel



and shifter panel



Lot of sanding fiberglass but hopefully all will be worth it at the end..

[Herblenny]

Couple of detail views of the turbo manifold.. that I didn't post.






And some of the random goodies that are going in in this car..

Aluminum rack..







Carbon Shaft.



FEED trunk thingy in carbon