V8 Exomotive Exocet

[YokotaS13]

He can build it. but its not going to be cheap.

a guy in ohio is selling his for 25k iirc.
you can build one under 10k

No pictures to post. However, the front passenger and rear brakelines have been bent and mounted via Pclips and nutserts. i trimmed my engine mounts to lower the engine 2 inches in the engine bay since i wont have this car as low as i used to and wont be breaking road reflectors. The front subframe is now reconnected and struts connected.

I am picking up my rear subframe from powdercoat (royal blue with flake overlay), hte new diff carrier is here, both new rear lower control arm bolts, and front brake lines (i tore mine from too much steering angle and stock mounting locations.

tomorrow i have to grab some bolts, posterboard and then its time to tackle the upper firewall, and ill start mounting/running wireharness, starter relay, fuel pressure regulator, etc etc

Read more: http://www.mevowners.proboards.com/i...#ixzz1vvsJRfjE

[Elbow]

I'm not an engineer but why would the tubes be above the square tubing at the front?



I'd just assume it would be stronger in the event of an impact mounted behind? Just curious, not sure if more is added down the road or what.