you need to figure out which ecu you're running, get a pinout, and run the wire to the correct location on the ECU plug, then the other wire is for the oil pressure sensor i think.
you need to figure out which ecu you're running, get a pinout, and run the wire to the correct location on the ECU plug, then the other wire is for the oil pressure sensor i think.
aaahhhh shit!!!! gunna have V-TTEEEEEEECCCCCCCCC!!
GOOD SHIT ENJOYLOL
NIKON D90 | Sigma 10-20mm | 18-105mm | 50mm 1.8 | SB-600 speedlightNIKON Squad
PR3 and heres the pin out. i have 2 wires run into the car from the vtec noid. ive tryed puting them in the place as shown on this link to the diagram. and no luck. i had a ls/vtec before so i know when it comes on and its not.
do i have to hook up a knock sensor? if so where is it?
the car runs fine without but i need to hook it up to make sure nothing is wrong with the noid.
http://www.ff-squad.com/tech/wiring/wiring.88-91.jpg
yes i am....
If I was you I wouldn't mess with the VTEC wiring. Because if you mess up this what could happen to you.
BUY MY HATCH <--click the link, cuz.
funny,i doubt it. someone with real info feel free to chime in at anytime.
yes i am....
hahah fuuniest shit ive seen!!!!Originally Posted by AirBrcak
If I was you I wouldn't mess with the VTEC wiring. Because if you mess up this what could happen to you.
NIKON D90 | Sigma 10-20mm | 18-105mm | 50mm 1.8 | SB-600 speedlightNIKON Squad
Posting Permissions
Reply With Quote