Can you bore a B18C1 to 90mm??

[Crosswyse]

90mm lolol! What compression? It would crack in between the cylinders with any amount of boost. I'd give less than a day.

Now 86.62mm is believable. Still retarded but whatever. DD?

5 years ago I posted a dyno vid on here after we bored a B20z to 86mm for RSX-S pistons using an undisclosed stock connecting rod, topped with a built b16 head. N/A 207hp/155ft-lbs

lol! Coming from someone that's never made a knowledgeable contribution to the Forced Induction [or NA] forum(s) other than one post regarding a rotary engine.

http://www.importatlanta.com/forums/...archid=3001617

its going to be a drag car. and this exact setup, when it was running NA, made over 260 Hp for entire race seasons.

[Vteckidd]

its going to be a drag car. and this exact setup, when it was running NA, made over 260 Hp for entire race seasons.

Dyno Sheet please

[Crosswyse]

Dyno Sheet please

When the motors built I will post one. And i knew it wasnt 90mm. just messing with yall, but you get all offended and take it personally.

[EmminoDaGreat]

When the motors built I will post one. And i knew it wasnt 90mm. just messing with yall, but you get all offended and take it personally.

Lol right...

[Barefoot]

When the motors built I will post one.

na he wants to see 1 of that 1. there should be 1 if it made it an entire season.

its going to be a drag car. and this exact setup, when it was running NA, made over 260 Hp for entire race seasons.

And i knew it wasnt 90mm.

right u sound like ever other dumbass noob.

just messing with yall, but you get all offended and take it personally.

find somebody who has.