7 worst ways to mod your car (Most of this applies to IA!!!)

[twinj]

^^That green bucket of bolts is mine. I would agree that I would loose all contests when it came to looks. But I could care less about looks. It's what's under the hood that counts

Nah I asked cause I seen your car before, and just didn't think that it was yours. That 626 is clean though all you need is to STOP WRITING ON YOUR SH!T, and to wash it you'll be golden.lol


What about the H.I.D.S that are considered DOT approved? Anyone

[blackshine007]

Nah I asked cause I seen your car before, and just didn't think that it was yours. That 626 is clean though all you need is to STOP WRITING ON YOUR SH!T, and to wash it you'll be golden.lol


What about the H.I.D.S that are considered DOT approved? Anyone

I don't think there's an aftermarket HID that is DOT certified for HID lights. But, I can tell you that most of your projector beam headlights are more suited to handling the light pattern of HID's. Just make sure that when you look inside the light that you have a wall looking item on the inside. It will be on the bottom side. When you shine the light on the inside, the beam gets reversed courtesy of the the shape of the lense. The block off plate is what is causing the cut off line when you turn the headlights on and point them at the wall. I think it's safe to say that as long as you have the block off plate within the inside of the light housing, it should be more than adequete(?) for HID's just be sure to adjust the level accordingly because it's gonna be pointing higher with the HID's.

As far as the car goes, I got extremely bored oneday and went crazy with my daughter's concrete chalk. I've since washed it. I want to primer it and paint it satin black and leave at that. I have zero primering skills but I'm pretty certain that if I tried, I'll probably do pretty well.