Quote Originally Posted by vtecgsrguy
do it yaself!!! take loosen the brake assembly and remove the caliper.and on the rotor,loosen the phillips secrew! (which will be a ***** & will probably strip) so have ya a dremell ready to cut it out!..lol... and remove the rotor.then knock out the stripped studs.then put new ones on!! make sure ya put wheel back on and tighten it down good then take it back off to make sure the studd went all the way in good. hope that helps but is the only way i could think to describe it..... sorry if its a little blury... help him out guys!!
If you put a ball peen hammer on the head of the screw (the rounded end) and use another hammer to hit the back of the hammer a couple of times, the screw will loosen right up, thereby eliminating the need of a dremel to cut the head out.