skunkworks stage 1 cams are outdated. If you were to use those, you mind as well use CTR cams or '01 ITR cams which are the same. The oversized valves aren't necessary either for that build. As for those 11:1 cr pistons, before you do that you should have the block honed anyways, but in this case you should get it bored .25 over so you can use oversize pistons. These will benefit you considering the b16 platform is torqueless.

what are your goals? HP #'s?

P.S. Check out vteckidd's NA guide in the "ALL MOTOR" forum. Its stickied at the top. This should help you a little bit. If it was me, I would ditch the b16 block and go bigger. (LS, GSR, B20)