jdm dohc zc swap going boost??

[SiRed94]

d16 pistons rods and everything works....im building a 400whp zc now as we speak for my girl.

this was gunna be the build in my 4dr but i went with a Z6 instead... but yeah you can just get pistons and rods made for any model d16 engine.... the same goes for the Turbo manifold... the sleeves on those are actually slightly thicker than the SOHC's, I've seen several ppl post the block and run over 15 psi without cracking the sleeves... not saying you should ... but, with proper tuning it can be done... the only downside for me was that they come with composite headgaskets and with the boost i was planning on running i would've rather had a multi-layered steel one... cometic offers one, but it's for a 76mm bore... but you could have them make you one for stock bore or bore the cylinders... also, webcamshafts, gude, and i think exospeed offer cams for the ZC... G/L with the build

[-S Double C-]

this was gunna be the build in my 4dr but i went with a Z6 instead... but yeah you can just get pistons and rods made for any model d16 engine.... the same goes for the Turbo manifold... the sleeves on those are actually slightly thicker than the SOHC's, I've seen several ppl post the block and run over 15 psi without cracking the sleeves... not saying you should ... but, with proper tuning it can be done... the only downside for me was that they come with composite headgaskets and with the boost i was planning on running i would've rather had a multi-layered steel one... cometic offers one, but it's for a 76mm bore... but you could have them make you one for stock bore or bore the cylinders... also, webcamshafts, gude, and i think exospeed offer cams for the ZC... G/L with the build

we plan on run 20-25psi on the stock sleeves. It's been done many times and it's about to be done again.

[JDM onlyy]

we plan on run 20-25psi on the stock sleeves. It's been done many times and it's about to be done again.

Post up on updates and when its dones!!

[SiRed94]

we plan on run 20-25psi on the stock sleeves. It's been done many times and it's about to be done again.

haha hell yeah... i was surprised at how damn thick the sleeves were when i popped mine open...