building a motor and have a few ?'s

[Vuongy_Dong]

I'm thinking of building a B16a1 bottom end with a gsr P72 head that I have sittin around.

1st- Is this a good combo, and what would it be considered(like ls/vtec)?

2nd- I want the highest compression with stock internals so was thinking of CTR pistons on stock PR3 rods. Or would PR3/P30 pistons be best?

Last- The head has ITR valve spings and retainers so I was going to get ITR cams. Whats the best injector to use with this setup?

1.No, is not considered LS/Vtec. b16 can be a fun motor to rev high with and have fun with, depending on what car it goes in.

2. IMO, i would do LS/Vtec and screw the b16. More torque, more power.
ctr pistons go well with the b16 bottom end.

3.stock gsr injectors are fine. you are not built nor have high compression pistons.