"Mr. Freeze" Methanol/Water Injection Features:
Very simple & effective kit.
Boost activated and metered by jetting
Can be used for all centrifugal superchargers, turbochargers, and Kenne Bell & Whipple twin-screw superchargers. Can not be used for Eaton superchargers!!!
http://www.andersonfordmotorsport.co...e.html#ysidyno
AFM Mr. Freeze Methanol/Water Injection Kit
Engineered by Anderson Ford Motorsport, Mr. Freeze is a universal methanol/water injection kit designed specifically for both carbureted/EFI supercharged and turbocharged applications only. Mr. Freeze is the most cost efficient and highly effective methanol/water injection kit on the market. Being activated by boost and metered by jetting, Mr. Freeze is easily optimized. Mr. Freeze is an easy bolt on for all centrifugal supercharges and turbochargers. In initial testing, AFM has documented up to as much as 90 additional rear wheel horsepower using 93-octane pump gas. With the proper tuning and 100 octane racing gas, Mr. Freeze was capable of an additional 115 rear wheel horsepower on a mid 650 horsepower Mustang. Higher horsepower gains are achievable on higher horsepower applications. Find out what Mr. Freeze can do for you.
100+ Horsepower With Windshield Wiper Fluid
That’s right! Simply use windshield wiper fluid and that’s it. No need for expensive fluids made by other companies. However, don’t just use any type of windshield wiper fluid with your Mr. Freeze. You will want to use windshield wiper fluid rated for –20 degrees or greater below zero. It’s this type of windshield wiper fluid that contains METHANOL to keep it from freezing. It’s also the important ingredient that produces the cooling effect thus dropping your air charge temperatures and consequently increasing power and allowing you to run more timing and less fuel. Here’s the best part you can purchase the methanol/water mix for as low as $3.79 by Motorcraft.
Complete & Ready to Run!
This system comes complete with instructions and everything needed to install and run on your supercharged or turbocharged application minus the fluid. Installation is a breeze, no pun intended, requiring approx. 30-45 minutes to install. Mr. Freeze methanol/water injection kits deliver maximum value for your performance dollar making it a must have for every turbocharged or supercharged applications.
Industry’s Most Cost Effective Methanol Injection Kit
That’s right! This is the industry’s only methanol/water injection kit under $190.00. This highly effective cost efficient unit does not require electric pumps, switches, relays, fuses or electrical wiring harness’s as do all other competitors systems. Thereby making this not only the most cost effective and easiest to install system on the market but also the most reliable as there are no pumps, fuses, switches or ugly wiring harness’s to worry about failing. Offering horsepower gains comparable to competitors much more complex systems.
Features Include:
1 3/4 quart tank
All necessary tubing, hardware and jet
60 degree drop in air charge temperature
Increases octane by several points
Allows for higher levels of boost then normally achiavable without
Allows for increased timing
Important Notes:
Requires only basic hand tools to install
Failure to retune the application can result in a loss of horsepower power as it will raise the air/fuel ratio a full point.
Installation Time:
Installation time approx. 30-45 minutes
Reply With Quote