I am running a built LS/VTEC motor in my ek. I just had my head rebuilt and the machine shop that did the work didn't do a good job or re-surfacing the head and now it leaks oil all over the place. Thats the only issue that i have with the motor right now. My question is, i am going to take the head off again and get it re-surfaced at another machine shop. So iwas wondering what would be the best head gasket to use on my set up. Its a B18B1 block with eagle rods, SRP pistons, Total seal rings, ACL bearings, ARP head studs. The head is a 91 PR3 B16 head with crower stage II cams, oversized valves, springs and retainers, fully ported and polished head, and AEM cam gears. My turbo that i am running is a turbonettics T-66. I plan on running around 16-18 PSI onthis set up. So i just want to know what would be the best head gasket to use. I have a 97 GSR OEM head gasket on it now. I have heard of people using a LS head gasket?