What's the status on your whip(s)? Waiting on parts? Almost done? Ready to ride out?
Mines up for sale so I can get a car again. w00t w00t.
(poll is for jokes)
-Ant.
well.. i broke a axle and this other part
bought a axle.
until i get the other part, its sitting in my driveway![]()
my shit is always broken
Hoping it does not let go on the dyno again, if it does I am trading it in for a Evo x
2006 Evo IX - Bolt ons
waiting on new turbo, ups says it will be here tomorrow...
NO ADVERTISING
-IA MANAGEMENT
should be getting my friction plate in today for my flywheel. then i should be ready soon
Where's the "let's race now because my car is going under the knife(er welder) in the next few months for upgrades" option?
JJSPEC RACING - Central Ga's source for performance parts,fabrication, tuning, general repair and a whole lot more! 478 621 5000
The mustang just got fixed and the supra is down waiting on a water pump, serpentine belt, and a 2nd turbo (but is up for sale in current condition).
Val For President
R.I.P. Our Dear Leisa..
ASAP N.E. Chapter VP
No more supra
__________________________________________________ ________________________________________
NIKON Squad member| NikonD40
Mustang is about to go in for paint, everything else is good, just need some seat time in it.
"Racing is life. Anything before or after is just waiting." - Steve McQueen
im happy with where im at although ill actually "never" be done!
want drilled and slotted rotors, mugen HT, dual exhaust converted to single, and supercharger...then i may be done![]()
tranny and cv axle are finally fixed, so im ready to ride out
just waiting on some time off and some dyno/tune time
INSERT SIG HERE>>>____________________________
need thicker head gasket installing arp head studs... reinstall the meth kit and TUNE!!!!!!!!!!!!
Ready to race, and too slow to race.
Will be race ready Sunday night....btstone where you at?
if you wanna run sunday night call me. ill drag your ass at the southside meet
hopefully sending the new block off this week to be bored and then just swap all the internals over and go retune....
Then sale my truck and get a friend of mines hatch to DD
11.7@116- All motor H2B Integra
My car just smoke checked the fan controller and I'm still waiting on a hood. Hopefully in the next two months I will have my 8.8 9" bearing conversion and 31 spline axles installed as well.
The Shitbox
my trucks in the driveway with a fresh oil change waiting to be hooked to the trailor and the car's in the garage waiting to be put on the trailer.
can't wait for next friday....gonna try to lower my single shot time since it's a little cooler out![]()
* For Sale.
"Cool car" less.
Anti-Nutswingers Crew - Member # 001