PDA

View Full Version : ef with d16z6 swap


jdmalltheway
09-06-2011, 11:50 AM
i have a cel on and it's a 17 which is speed sensor. speedometer works but i can't figure to get rid of the cel, i try new ecu and it'll still pop up the same cel. any help
*EFilliated*
09-06-2011, 12:54 PM
disconnect the battery for a minute
jdmalltheway
09-06-2011, 01:20 PM
i try that already. i reseted and after i drove it for about 20 miles and it pop back up again.
green91
09-06-2011, 01:56 PM
Have you changed the cluster or anything on the car? The VSS is in the cluster so its either a bad cluster, or a break in the wiring between the cluster and ECU. This is assuming you kept a cable-clutch trans in the car and have a cable speedo.
98blackcivic
09-06-2011, 04:14 PM
maybe you should learn proper grammar!
jdmalltheway
09-07-2011, 08:54 AM
98blackcivic your a dumbass!!!! Is that proper enough for you
jdmalltheway
09-07-2011, 08:56 AM
Have you changed the cluster or anything on the car? The VSS is in the cluster so its either a bad cluster, or a break in the wiring between the cluster and ECU. This is assuming you kept a cable-clutch trans in the car and have a cable speedo.

Yes I kept the cable tranny and it does have a cable speedo. I haven't try a new cluster yet and it was going to be my next step. I got a crx si cluster laying around but I'll have to do some wiring because 89 si wires is little different from 90-91 si.