rebuild d16 motor not starting

[jay_boi]

well as my title says i have a rebuild motor i just did on my eg but some how i cant get it to start or other words turn over .... itll sit there and crank but wont start... i dont know wats wrong with it ........

i have a brand new dizzy put in it .... i got fuels coming in but yet its not working ..... so ive check it like how ever many time and well in cylinder 2 n 3 is the only two cylinder that works ... so please help me ....

[B18c1Turboed]

Check for spark, and do you have any codes or check engine light on?

[Cynical 1]

mechanical timing set right?
distributor 180 degrees out of time?
spark plug wires in right order?
everyhting plugged in?

[CptWitwiki]

Valves adjusted properly? I didn't adjust my valves when I rebuilt my engine and it wouldn't start BC of that

[RBS]

piston rings gapped and installed right?

[jdmalltheway]

upgrade to b series

[Captain-Obvious™]

Check compression. My motor had spark and fuel and wouldn't start because of bad compression.

[4wslude]

is the ecu pluged in i forgot to do that one time

[jay_boi]

thanks to all of ya
first it was my crank angle for my dizzy that was off and my timming was two tooth off
so thanks alot for the help

[jay_boi]

urgh now the car starts n now a new problem
that is first my car does this noise a grinding noise from the tranny and my clutch is cricket
and when i step on the gas with pressure it does this high pitch noise kinda like metal hitting each other