crankshaft pulley!!!!

[bullet67]

this has gone way past ridiculous, motor is out of the car i've heated this bolt, tapped it with a hammer heated it again tried the same method, used an air wrench. stubborn damn bolt someone tell me they have an idea. :thinking:

[DustnU]

Try spraying it with PB blaster or WD40 (soak it) then hit it with a higher torque impact gun.

[bullet67]

its soaked now just sitting in the garage gave up for tonight haha. guess ill borrow another impact gun tomorrow i only have the one. i've never had good luck with these bolts.

[RBS]

if it has a flywheel on it, thread a bolt into one of the threads and place another bolt to jam it. have a buddy hold the motor and use a longgggg pipe with 1/2 socket to break it

[slostang]

PB blaster and a bigger impact. We use a snap on 1/2" gun at work with 1200 ft/lbs and it STILL has trouble on some honda crank bolts. for some reason honda likes to get them hulk tight.

[EmminoDaGreat]

Bet my impact will take her out' haven't met a bolt she didnt remove :)

[bullet67]

yeah i figure my impact just wont cut it i purchased a big ass pipe today and thanks for the tip on jamming it on the flywheel side.

[94_teg_ls]

had this issue on my sol alot with every motor take the impact put it on loosen hit it for about 5 seconds put it on forward for 5 secs repeat over and over it will pop loose

[Tech5]

There is a HONDA crank Pulley tool for this reason I have both for the civics' and accords .... you need a good 150 psi and a strong impact I have a Snap on 800ft and it takes everything off ....


If you don't have anything strong enough get that Crank pulley tool and a Big breaker bar and a exhaust pipe to extend your leverage .