H22 keeps blowing head gasket

[Jwall2323]

I just put a H22 in my wifes accord and it keeps blowing head gaskets. Any ideas why? I bought brand new ARP head bolts. Torque spec is 80fp and I torqued it down to 100fp this last time. I hasnt overheated either...

[Black4DrEK]

Coolant hoses are correct place?

What gaskets are you using?

[K24cb7coupe]

head or block might be warped.

[Black4DrEK]

^^ If your doing everything correct..

that IS probly your problem right there...

ALWAYS get the heads checked out before putting back on.

[EmminoDaGreat]

How do you know it keeps blowing the head gasket? You can stretch ARP bolts by over torquing them, and if it hasn't overheated what makes you think its a headgasket? I would pressure test the system, and make sure fans, and radiator cap, temp sensor are all in working order.

[EmminoDaGreat]

And as stated prior, the head or block can be warped, or have hairline crack somewhere.

[.:Stirfry:.]

two words
indian head gasket shellac compound!

get it at your local part store, best couple dollars youll ever spend.

[xero_xero]

shelllllllllac....

warped head/block x 3.

[Jwall2323]

Yes, i got the head milled, and the block decked. it is all good. I know it is blowing headgaskets because it sounds like a wrx, and lost some compression in cylinders 3 and 4. It is an oem gasket, the radiator hoses are in the correct places. and all coolant sensors/system is working properly. After i let it sit for about a day and cranked it, it was blowing white smoke. bad. Can a machine shop check to see if the head is cracked?

[xero_xero]

they do a vacuum test to see if it cracked.