Heater doesnt work

[k20ej8]

Just wondering why my heater doesnt work in my 96 civic dx. Too cold to be dealin with this. lol

When i turn the heater on i dont feel any air at all even when i blast it to full

heelllppp

[Barefoot]

Just wondering why my heater doesnt work in my 96 civic dx. Too cold to be dealin with this. lol

When i turn the heater on i dont feel any air at all even when i blast it to full

heelllppp
make sure the core is getting coolant. make sure u have coolant. make sure u have no leaks. make sure your fan is blowing.

[*EFilliated*]

is the hose hooked up?

[Black4DrEK]

You dont feel ANY air?

check the blower motor, test it.

[uproot]

^what he said.

[dallasb84]

mayeb your heater bearing went out

[Theycall_Metue]

You dont feel ANY air?

check the blower motor, test it.
x3 way to check if its still good is to take it out and hook a negative and positive wire from your battery to the blower motor ( hold the bottom of the blower motor and grip it good ) it should spin. if it doesnt than the motor is dead. if it does than your switch is bad or no power is going to it

[Tech5]

x3 way to check if its still good is to take it out and hook a negative and positive wire from your battery to the blower motor ( hold the bottom of the blower motor and grip it good ) it should spin. if it doesnt than the motor is dead. if it does than your switch is bad or no power is going to it

NOOOOO

Want to start a fire!!!

hOLLA SHITT

take a test light and check the power and ground from the blower connector you can turn the switch on and off to see if its getting P&G
If it is tap on the blower while your switch is on High if it comes on replace it, if it doesnt replace it because your getting a P&G so it has to come on... If your switch is on high and it works but not on the low speed its your blower resistor. If you don't have a P&G check fuses

[Tech5]

mayeb your heater bearing went out
Idiot

[Theycall_Metue]

NOOOOO

Want to start a fire!!!

hOLLA SHITT

take a test light and check the power and ground from the blower connector you can turn the switch on and off to see if its getting P&G
If it is tap on the blower while your switch is on High if it comes on replace it, if it doesnt replace it because your getting a P&G so it has to come on... If your switch is on high and it works but not on the low speed its your blower resistor. If you don't have a P&G check fuses
how the hell will it cost a fire to test the blower motor lmao
its a 12v current that goes to the blower motor at high speed

[JJSPEC Racing]

Turn it on and hit the bottom of the blower motor with your hand. If it starts working it will be time for a new one as the brushes are about worn out in your blower motor.

[ATL86]

Can't overlook faulty blend doors. Make sure they shift properly when you slide the climate control from side to side.