Log in

View Full Version : engine swap


BAC
08-07-2009, 12:48 PM
is engine swap fast? also, does anybody knoes how to do it? and how much would you charge?
EmminoDaGreat
08-07-2009, 12:50 PM
We can do any swap you need. Let me know. 678-363-6789.
And what do you mean is an engine swap fast? Can it be done fast, yes. and Depending on what motor it can be quick .
Arm&hammer
08-07-2009, 01:05 PM
more info dude.
What car and what swap?
BAC
08-07-2009, 01:09 PM
sorry for a 1995 acura integra. Ls motor. take out and put another one back in.


more info dude.
What car and what swap?
wrekonize
08-07-2009, 01:13 PM
2-3 hours average....
BAC
08-07-2009, 01:14 PM
to take the old one out and put a new one in there? also, it would be nice if i get a brief summary on how to do it.


2-3 hours average....
Barefoot
08-07-2009, 01:20 PM
to take the old one out and put a new one in there? also, it would be nice if i get a brief summary on how to do it.unbolt the old, put it, drop in the new, and bolt it in.
BAC
08-07-2009, 01:25 PM
can you explain that in a easier way.


unbolt the old, put it, drop in the new, and bolt it in.
Barefoot
08-07-2009, 01:41 PM
can you explain that in a easier way.pull old install new. simplest it gets.
NoWAyItZTOMmY
08-07-2009, 02:33 PM
take axles out
unbolt linkage, exhaust, ps, ac
unbolt motor
take trans off
put trans on new
bolt everything back up
IntegraXTR
08-07-2009, 03:36 PM
If you never done it before, then take it to someone that knows what they're doing. Either that or pick up a helms manual and start reading.
j0nbunklah0m
08-07-2009, 04:22 PM
where are u located?
Motivation
08-07-2009, 05:13 PM
take axles out
unbolt linkage, exhaust, ps, ac
unbolt motor
take trans off
put trans on new
bolt everything back up

Why would he take trans off and put new trans on for a motor swap? Why you got to change the trans? :taun:
Barefoot
08-07-2009, 05:16 PM
Why would he take trans off and put new trans on for a motor swap? Why you got to change the trans? :taun:if its a manual he is correct trans will have to come out or be dropped.
VickNotic
08-07-2009, 09:01 PM
it's pretty damm easy, It's like taking candy from a baby only if you have all the necessary tools

you'll need

10mm
12mm
14mm
17mm
19mm
32mm for your axle nut
pliers for some stuff
needle nose

axles comes off
rear mount
passenger side mount
driver side mount
ac side mount
tranny side mount
3 plugs harness side of passenger
3 plugs harness on driver side
3 ground wires, tranny & valve cover, near thermostat housing
knock out the gator tooth that holds the shift linkage i use a 3/16 to knock it out with hammer & 12mm
take off 2 12mm bolts that holds the slave cylinder
header to catback bolts believe it's 14mm 2 of them
take out radiator, for more room to work
and them boom boom poWW engine hoist that bish out and take off

you should be able to knock this out in 2-3 hrs 8D