PDA

View Full Version : crx dpfi-mpfi swap


hadouken
06-15-2009, 03:08 AM
i swapped my crx from the d15b2 to the d15b7 and me and a friend wired up everything and all im getting is a click its not turning over any help? we looked up all our information on honda-tech.. the starter is still good, fuel pump cuts on, do i need to buy the obd0-obd1 conversion or can i splice wires into the obd0 ecu... b/c thats the way we have it now. we have the obd0 wireing harness 0bd1 dizzy... any help will be appreciated
hadouken
06-15-2009, 02:45 PM
bump
wrekonize
06-15-2009, 02:52 PM
check the ground on the wire harness...right on the thermostat housing
jdm eg99
06-15-2009, 03:49 PM
its connected ! next...
preferredduck
06-16-2009, 01:45 PM
some wires may have to be switched for the dizzy, iacv has to be switched and a few others. where are you located b/c it could be a number of things causing chaos. i have looked into converting my hatch for about 2 years. make sure the ecu you are using supports the sensors in the dizzy. i think the TDC, CKP, and another sensor is in the dizzy and if not wired right our not going anywhere.
hadouken
06-17-2009, 12:38 AM
im near downtown winder but the car is in winder too but its on the other side of town at my friends house