PDA

View Full Version : Power Mods Accidently Over filled oil on my boosted B16.


IloveLindaT
06-01-2009, 01:09 AM
Well today I accidently over filled my oil. I thought it was at a leveled position so I check the oil and it seemed low. I added 1 1/2 quarts, and it was a little over the second dot on the dipstick. I drove around and it started blowing white smoke out not even in boost. I wonder if this has anything to do with the extra oil that I added..

I guess its time for a compression test... Or may be the turbo seals going bad.
tdurr
06-01-2009, 01:48 AM
or time to drain out the extra oil then go from there. how far did u drive with the extra oil in the car?
NVEOUS
06-01-2009, 09:05 AM
White smoke. hmmmmm what does it smell like??
LostSolVTEC
06-01-2009, 11:44 AM
white smoke is usually coolant, but when an excessive amount of oil gets in the exhaust it can come out white too.

Like the second poster said drain it out and start over with the correct amount of oil. If it still does it troubleshoot from there
green91
06-01-2009, 03:16 PM
if its just a hair over the second dot, its probably not the cause of your smoking. i always ran an extra half-quart on my boosted d16.
Barefoot
06-01-2009, 03:25 PM
drain the oil dont over fill problem solved
Axix23
06-03-2009, 01:52 PM
if its a tad over the second hole, your fine.. Your smoking could be oil going into your downpipe/exhaust through your turbo..
highspeed
06-05-2009, 06:57 AM
sounds like you got other problems if you are putting that much oil in your motor. Im with green91 on this
dkjohnson04
06-07-2009, 09:33 PM
my car smokes quite a bit too when not in boost and from what i gathered its cause i have no oil restrictor on my turbo and its gettin too much oil psi and blowing past the seal on the exhaust housing...........as far as the oil level goes just drain some out and add till its good or better yet just do an oil change and put the right amount. the correct amount for a b16 i believe is 4.2 quarts..someone correct me if im wrong!
Barefoot
06-07-2009, 09:51 PM
the correct amount for a b16 i believe is 4.2 quarts..someone correct me if im wrong!for oil change, including filter 3.8qt
for oil change, without filter 3.5qt
total fresh built motor 4.5qt

straight from the FSM