FS- Bosch WBO2 sensor $50

[Doppelgänger]

Bought this to replace the WBO2 on my Hydra 2.17... found out it's not compatible...but will work with Hydra 2.5. Can be used on various custom wideband setups.

Bosch #15401 (L2H2)

Has maybe 300mi on it. I had to splice it onto the Hydra WBO2 harness (not included) so you'll get it with cut wires and the original connector that same on it...sorry.

$50

[IloveLindaT]

Hmm if itworks with a ZEITRONIXs wideband Ill buy it.

[Doppelgänger]

Hmm if itworks with a ZEITRONIXs wideband Ill buy it. What WBO2 does it currently use?

[Cool Cat Racing]

Damn Mike, I was hoping that would work. I was following your thread on Miataturbo. If you find any that are compatible with the 2.6 let me know. I'm overheating the one on Thunder over 15psi but my AEM stays true.

[Doppelgänger]

well, if the one from the 2.5 will work on the 2.6...then this one will work. What is the #stamped on the wbo2 that came with yours?

[Cool Cat Racing]

Don't know, I'll have to check. Ours is the 2.6 as well and I want it to be able to read on boost but it overheats and pegs lean. I know its the sensor since its only a few inches from the AEM sensor and it always reads true.

[wazzyatl]

will this work with an AEM uego gauge setup