Power Window Not Working....

[xlilvi3tx]

Well i was changing out door panels and all the sudden the passenger side stopped working.
I first changed out the driver side and rolled both window down to see if it work properly and both side did. Once i took out the passenger side and swapped it with the new one and put everything back together, i tested to see if the passenger window work.... and it didnt. The driver side window works BUT the switch to passenger side doesnt either. That window doesnt even make a noise or anything.

I have..
-checked the fuse and it was good
-replace the fuse
-swap the window switch
-check the fuse under the hood and tried switching it

none of these work.... Well the question is could it be a bad wire somewhere? and is there anything anyone else anyone suggest? I would really appreciate any helpful info. And its a 00 Integra if it helps.... Thanks in advance

[gsrteg]

use a volt meter and start checking the terminals and wires that hook up to the switch and etc...This process always works for me. Then, once you pinpoint your problem; solder, cut, extend, or tape any wire necessary. hope this post, help in someway...peace.

[chip P.]

yep, exactly what this guy said. first sheck the actual connector for snapped connections or broken wires. voltage drop test time lol.
use a volt meter and start checking the terminals and wires that hook up to the switch and etc...This process always works for me. Then, once you pinpoint your problem; solder, cut, extend, or tape any wire necessary. hope this post, help in someway...peace.

[xlilvi3tx]

thanks alot. yall got my reps. anymore suggestions anyone?

[xlilvi3tx]

i found out whats the problem. thanks for the help!