Brian Crower stage 2 cams? b16

[LDTFbsst]

Im trying to figure out what set of cams would work best with my b18c1 block, bottom end fully built, GSR tranny with LSD with B16a2 head (si) with no real work done to it, im planning on upgrading the springs and retainers of course.
Any Ideas?
Anybody have any experience with any Brian Crower's cams?:???:

[Tech5]

Depends on your set up....what has been done to the bottom end? you say built meaning what Higher compression pistons, or just rebuilt stock or what, that is a factor an your head to determine whats best for your set up, you going boost, nitrous, supercharger, N/A are you going to get it tuned? If you got just a simple mild set up stock bottom end, I say just change your exhuast valve springs to Type r, and install Type r cams, out of a 01 model....But if it was me, ill go with stage 2 Skunk 2 cams, with there valve springs, an retainers, an get it tuned after that, 255 fuel pump, bigger intake an throttle body, an roll

[LDTFbsst]

Well I have high compression pistons, lightweight flywheel (even though I know that dosent matter in this situation), bigger intake, and throttle body, and im going to get it tuned shortly after putting the cams in, its already been tuned with the setup I already have. I mean maybe a longer while afterwards, im going to supercharge it, but not too, too soon. just need some ideas cam-wise.

[Tech5]

then go with Skunk 2 stage 2 an there springs an retainers