PDA

View Full Version : WtB camaro rear end!!!!!!!!!!!!!!!!


silversol
03-09-2007, 01:06 AM
I know this is not the best place to look but I need a rear end for my mothers 99 camaro. the car is a v6 auto but I will also take a v8 rear end I need this asap!
i4_garage
03-09-2007, 11:32 PM
damn..i got the entire Passenger Quarter cut...lol....send me some of ur damages and i see if i have wat u are looking for
Annihilation
03-10-2007, 12:20 AM
you mean axle or rear body part?
silversol
03-10-2007, 01:13 AM
sorry I ment rear axle!
Annihilation
03-10-2007, 01:35 AM
IF YOU NEED IT FOR THE REAR DIFF, I GOT ONE...MINE HAS A BAD PASSENGER OUTER BEARING/POSIBBLY BENT FACE TO SHAFT.....LIMITED SLIP FROM MY 1996 LT1 6SPEED
$150
silversol
03-11-2007, 01:12 PM
IF YOU NEED IT FOR THE REAR DIFF, I GOT ONE...MINE HAS A BAD PASSENGER OUTER BEARING/POSIBBLY BENT FACE TO SHAFT.....LIMITED SLIP FROM MY 1996 LT1 6SPEED
$150

I dont need one with the same problem as mine
2.0civic
03-11-2007, 01:20 PM
will a blazer rear end work?? ill see what i can do since we have a couple work blazers here and a few s10's...LMK man
silversol
03-11-2007, 01:28 PM
will a blazer rear end work?? ill see what i can do since we have a couple work blazers here and a few s10's...LMK man

i dont think so
Blitanicle99
03-11-2007, 10:24 PM
Thats 10 bolt rear right? Swap the brakes and it might fit. Just axel length difference
jfman
03-12-2007, 02:10 AM
Thats 10 bolt rear right? Swap the brakes and it might fit. Just axel length difference
Not the same blazers have leaf springs and camaro have regular spring torque arm/panhrd bar setup.

No other rear end than an F-body rear end will fit.
silversol
03-20-2007, 10:15 PM
anyone I need this asap!
AnthonyF
03-21-2007, 06:47 PM
car-part.com try there
Blitanicle99
03-22-2007, 09:52 AM
Ok well take the set up off your axel and cut the leaf spring brackets off the blazer axel with a torch. Weld on the new setup on the blazer axel. It sounds far fetched but it works.
silversol
03-23-2007, 10:21 AM
Ok well take the set up off your axel and cut the leaf spring brackets off the blazer axel with a torch. Weld on the new setup on the blazer axel. It sounds far fetched but it works.

way to much butchering for me I think I am going to just get the stock rear end fixed :goodjob:
santacruz77
03-23-2007, 10:48 AM
go to pull a part
silversol
03-23-2007, 02:17 PM
go to pull a part
they dot have any