92 integra B18a1 motor and tranny: stock or upgraded(preffered)

[heggert]

I'm looking to replace my B18a1 motor and tranny, really would like to get a built head( no 404 cams / 403's preffered) and as far as block goes whatcha got? Really looking for a reliable replacement while I start my NA build on my curent motor and trans. thanks

[gsrteg94]

i got a b18a1 block. stock with all internals just need new piston rings. throw me an offer for it! I also have a bare ls head that will come with supertech valvetrain. and i also have jdm b20 pistons and rods. text me 678-485-1824!

[EmminoDaGreat]

I have 2 b18b1 longblocks. lmk

[Special-K]

and mine is a 92 also. and im in bethlehem, right down the street from you. hmu

[heggert]

LOL you still got that 2 door? I thought you were just going to fix it and keep it. is this the same engine that had the bent valve?

and mine is a 92 also. and im in bethlehem, right down the street from you. hmu

[Special-K]

i got full swap, can come drive the car before you buy. runs good. fresh rebuild only 11k on all internals. give me a shout 678-221-8712 name is brandon

[jdm_eg8]

If you need an alternator, speed sensor, fuel rail or extra dizzy cap with wires hit me up I've got it all for hella cheap.

[heggert]

keep it coming guys, it's going to be few weeks before i got the cash but I'm getting 2 storage buildings so i can clear out the garage. Im going to buy up as much as I can that way I do have extra stuff while I'm doing my build. any tips or advice while i'm doing this build? never worked on hondas til about 2 months ago. I'm a strictly toyota guy and just wanted to see if there was anything paticular to hondas I should know. thanks again guys.