- Throw out bearing
-
IA Member
- Rep Power
- 0
Throw out bearing
Help I have a 98 legacy that had a bad pressure plate that
Cause my clutch to slip. I open up the car after goin to the junk yard an taking
The plate of another car. So I put it on but now my car won't go in gear
I had to open back up the transmission only to find that my bearing
Clips keeps coming of when I push on the clutch. I need to how this lips
Is suppose to go back on so that it won't come of again. And I would like
To know where I can buy a new pressure plate,just the plat only. And if anyone could send me a pic of it that would be great to.
-
I looked and a new pressure plate runs around $100 why not get new ?
-
-
IA Member
- Rep Power
- 0
Yes looking for a new one right now,but I am wondering if that
Is the reason why my clutch pedal is staying to the floor when I push on it
-
IA Member
- Rep Power
- 0
I found one online today that cost 73 and some change.
Think I will get it.plus it's the oe part as well so I will go with that,
Lol I can't wait to get back into that car. I never new Subaru was
This good of a car
-
IA Member
- Rep Power
- 0
-
replace pilot bearing while your at it and grease that new throw out bearing before installing it
-
IA Member
- Rep Power
- 0
Yes so i got the new plate and my car is like new again lol. now to sell my 91 crx
-
- Throw out bearing
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules