Haltech E6K-8 stand-alone EMS
Used Haltech E6K-8 engine management system for sale.
Was used in a fox body application with a supercharger, but will fit mostly any other V8 application as well as 4cyl-6cyl.
Electronic Control Unit ( ECU )
Main Wiring Loom
2x Power Relays
Air Temperature Sensor
Coolant Temperature Sensor
MAP Sensor (Optional Extra) in either 1, 2 or 3 Bar
Throttle Position Sensor
Communications Cable
Programming Software
Instruction Manual
Ignition/Fuel trim module as well, about a 150.00 option
Some capabilities are as follows:
* Faster processor
* Four dedicated PWM outputs, up to 6 available.
* Faster serial link to PC
* New intelligent internal Reluctor Adapter
* Ability to run many newer, abnormal ignition triggers. eg Nissan and Subaru
* Flash-updatable firmware.
* Soon to be released Halwin Windows programming interface
* Software switching for all hardware setups , no internal DIP switches
* Internal Barometric Sensor
* Additional injector drivers now controls 8x low impedence or 16x high impedence injectors.
* Ability to import E6A, E6S, and now F9 maps
* Very soon to have dual on-board map capability
Everything is there for any boosted/NA application and it works as well as a F.A.S.T. imho.
I have a laptop as well that I will sell with the Haltech for an additional price if you would like.I know this is my first post on importATLanta, but rest assured I have many post on streetcarforums and and have a good rapport for selling parts.
$600.00
Thanks.
-Keith
Reply With Quote