well rip da 2/1/10 i share this story...

[laokid]

when i first got it it have a jdm front end on it fenders,bumpers headlights,hood that i sold and i also sprayed it with satin black kyrlon sprey paint (from a can fantip)from walmart cost bout 20 bucks and sanding time wheels didnt come with it and steering wheel, car needed minor work all the lines on the manifold were hooked up wrong,headlights were wired wrong,no battery,craked windshield,brakes didnt work,leaking anti freeze and needed a distrubtor,needed a tune up and clutch job and timing belt job not bad for a $600 dollar car..



satin black w/ snow flakes and jdm front end before i sold the front end and wheels


couldnt pick which bumper to use lol
92-93 oem bumper w/1st gen teg lip


90-91 oem optional lip

Toyota Starlet Rims OR

Enkei Mesh Rims

b18a1 w/s1 tranny 117k miles Fresh

Ground Controls&kyb gr-2 Struts Smooth Ride

And Just when i was about to do a clutch job and replace the windshield after all the rebuilding i've done this happens, thise yellow w/silver stripe wire burnt out which controls the rear defrosser,fog lights,turning switch,cluster operations(fuel,temp,rpm,)reverse lights,auto seat belts...odd not sure if its because of water or something..but i traced it from the engine bay to the cabin harness ....
--->
SO Fuck it I Could Of had It fixed, but Then I decided to part it out too much work lol


Rip DA9 2/1/10 bye bye