Results 1 to 3 of 3

Thread: 95 integra need help

  1. #1
    Senior Member
    Join Date
    Jun 2008
    Location
    Rome,Ga
    Age
    38
    Posts
    2,338
    Rep Power
    20

    Default 95 integra need help

    i just rebuild my integra gsr with a b18 in a si tranny but for some reason at low rpm it want to act like its misfirin so we came up with a solution it was the distributer so we change that then it ran good but this morning got in it start doing the same thing so what could make the distributer go bad ??//

  2. #2
    It's all about JDM.
    Join Date
    Feb 2008
    Location
    CA to GA
    Age
    35
    Posts
    720
    Rep Power
    18

    Default

    does, your engine light come on?

    Check ur ignition coil, located inside the distributor, see if it has the correct ohm readings (use a electrical tachometer to test). Check your spark plugs (if not fouled), then check each spark plug wires (with the electrical tach, for correct readings) see if not shorted, and check dist. cap and rotor. I'd advise using the helms manual or Factory man.
    I won't advertise because I'm not paying to

  3. #3
    It's all about JDM.
    Join Date
    Feb 2008
    Location
    CA to GA
    Age
    35
    Posts
    720
    Rep Power
    18

    Default

    If you ain't got a helms.or factry man. pM me, I can probably post it on here.
    I won't advertise because I'm not paying to

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
ImportAtlanta is a community of gearheads and car enthusiasts. It does not matter what kind of car or bike you drive, IA is an open community for any gearhead. Whether you're looking for advice on a performance build or posting your wheels for sale, you're welcome here!
Announcement
Welcome back to ImportAtlanta. We are currently undergoing many changes, so please report any issues you encounter with the site using the 'Contact Us' button below. Thank you!