CV axles replaced, still ticking noises... watf?

[changaroo]

soo...

i had a busted passenger side cv boot, and today i replaced the whole axle.

...and my damn car still makes a clicking/ticking noise. i have no idea what it could be now.

the only thing i did before this was rotors / replace pads. and that was last week.

what could the ticking be? any idears?

thanks

[Barefoot]

the axle may not be locked in. the other axle may be bad.

[csmiths]

i dont know when i heard it last night, it only sounded like an axel click, but could it be the other one.

[tubby]

im kinda havin the same problem but im only geting it wen my foot is off the clutch and im under a load. kinda weard. im stumped

[.blank cd]

What are you driving?

[changaroo]

What are you driving?

you shall see on sunday

[.blank cd]

you shall see on sunday

[patrick4588]

maybe dust shield on the rotor? maybe?

[Kaiser]

When the boot died it could have damaged the transaxle/diff? Does it do it in straight lines, or when turning?

[1SOL2NV]

push the axle in further ..... or replace the other axle ... problem should be solved .

[Benefit]

wheel bearing?

[Scotsman]

push the axle in further ..... or replace the other axle ... problem should be solved .

x2

[mikesEK]

x3

x2

[G.C]

if it popped out again. Check your Engine Mount. if its going back it can pop it right back out or cause it to break again.

[ash7]

Changaroo, put the camera down and give us an update

-jonathan