help on ambering corners
wussup ia? does anyone have any idea how to amber out corners? i would have gone ahead and bought them but they don't offer it for s14 zenkis.
i have seen it been done and also i have heard rumors but i havent been able to find any of the materials i need to do it. ANY help would be appreciated. just lmk thx alot people
Here's what I did for my DIY JDM Amber side markers on my EP...should work the same...
Go buy some RIT sunshine orange dye and mix it up really concentrated...I used like 1/3-1/4 of the amount of water they recommended for use on plastic. I put my ingredients into a small Pyrex bowl and put it on the stove over very low heat. I had just enough heat to see the mixture slowly churning. There was no bubbling or boiling at all. Make sure you use a vessel that will allow you to submerge them completely in the mix. I mixed them around with the chop sticks every 5-10 minutes for about 45 minutes. [Wash your hands after every mixing. This stuff will stain your skin.] I took them out of the bath and put them into a bowl of clean cold water. I let the water run over them until it ran clear. Let them dry before you install the bulbs and reinstall them on your car.
Left is a real JDM factory amber, right is DIY.
You must spread some Reputation around before giving it to KPowerEP3 again.
wow, sounds so complicated but looks fu*king amazing. think u can break it down a little bit more? and i will rep u whenever i can. thanks ALOT though....
wow.. i like. i think ill rep you even though i dont need to do this hehe
ahaha i know someone who made jdm integra tails. well he didnt make it.. HE SPRAYED PAINTED RED> lol i think it was some stain glass paint.. haha....
I give out reps....
yeh i know what u are talking about. lol but i found out how to do itOriginally Posted by khaxnguyen
can this be done to fog lights? not ambering... but like jdming? lol. coating them yellow?
well im doin them right now. ill post up pics if it turns out good.
mkay
Posting Permissions
Reply With Quote
