1992 Eagle Talon AWD shell FS

[DervhaneGSX]

Whats up guys, I am selling my AWD Shell only cause im stepping up to a later model DSM, The car is still put together but im taking stuff that im gonna need for the other Car! I will upload or send pics upon request.
The car is located in Albany GA where I live and I have used it as a DD and raced it at the track
INFO ON CAR
Car is a 4 bolt non LSD rear, its red will need a paint job but its not in bad shape, im leaving the full 3 inch Exhaust from the Turbo back on the car, it is already tapped for AEM wideband, Walbro 255 in tank, the battery has been relocated to the trunk, I am leaving the Eibach Prokit lowering springs on there and the GST rims, 5spd transmission no grinds at all is gonna be included and in the car with transfer case, im gonna keep my gauges I have 4 gauges in the car and my Wideband is mounted in the factory gauge cluster and I may leave that in upon request, I can take under car pics wanted for those interested! The chassis just rolled over to 150k and I have a clean non salvaged title! Also leaving on the car is the punishment racing short route FMIC with piping! So the car has a pretty good amount of basic mods to get whoever going in the Dsm world, also upon request I have a built bottom end to go with it depending on Buyer we can work out a good deal I want $1,400 for the car and that pretty much is a good asking price cause the mods along is basically like getting a free car, i just dont need to keep any of this stuff.
Im gonna sell the Eprom ECU separatly with DSMLINK unless buyer buys it also and we can do some kind of discount if purchased that way!

INFO ON motor

The motor just threw a rod last week, I was gonna keep the bottom end and rebuild it, the block was O- ringed, bored 0.20over std, Carillo Rods, Wiseco 8:5-1 pistons, ARP main studs and Head studs, I put 50k on motor its been together since 2007, and now only 3 rods are still good and all pistons, Carillo industries will sell 1 rod but they are not cheap about $200 for one but you gotta get the weight matched so it can be balanced, so if interested let me know cause building a bottom like this will run $750 on a set of rods, $450 on the pistons, and all other components, so let me know if interested in the re buildable block


interested buyer let me know I can send more pics by email or text, my phone number is 862 215 9776 and my email is [email protected] so let me know what you wanna see and its yours

This is priced to sell fast so I can get this 96 so let me know guys

[DervhaneGSX]

[DervhaneGSX]

uys, change of sell here really tryna get a different car So how I can do this Talon AWD Shell with walbro 255, battery relocated Tranny Transfer case and the 2g rims, $600(4 bolt rear)(4 bolt rear) 1g full 100% 3 inch exhaust,( o2 elim) so its 3 inch off the Turbo all the way back to OBX muffler $300 obo $300 obo Punishment Racing FMIC kit with piping, might have to add a peice for using a stock intake manifold $225 shipped Another 1g Transmission and Transfer case $300 1g eprom ECU $150 Y'all give me some offers here

[88NaCivic]

Good price man GLWS
If I had 6 Id be on this shell

[hatewearink]

glws