1992 INTEGRA HELP

[StarBwoy]

OK I HAVE A 1992 INTEGRA I PUT A FUEL PUMP IN AND STARTED IT AND IT RAN BUT IT NEED A AXEL HAD THE CAR IN THE GARGAGE FOR LIKE 2 MONTH THEN I BOUGHT THE AXEL .BEFORE I PUT IT IN I PAINT THE MOTOR AND ALL THE GROUNDS STUPID IDEA BUT I SCRAP THEN OFF . PUT THE AXEL IN AND SUM MORE GAS TRY TO START THE CAR AND ALL I HEAR IS A CLICKING NOISE COMING FROM THE DASH NOT THE STARTER. AND THE FUEL PUMP IS NOT COMING ON NEED HELP and i have a good fuel relay

IT HAS A NEW ECU AND DIZZY NEED HELP ASAP THANKS IA

[EmminoDaGreat]

main relay

[Tech5]

I would take the main relay out and take it apart and look very close to all the solider points and re solider them if cracked .Very simple fix I do it all the time never once bought a relay in my life .

[StarBwoy]

i forgot to tell yall the main relay works its clicking took it out of a running car

[Tech5]

check your fuses an is there a alarm on the car?

[terrytowe22]

Bad ground check thermostate housing ground off ur harness

[StarBwoy]

check your fuses an is there a alarm on the car?

i did all goood and i think there was

Bad ground check thermostate housing ground off ur harness

the ground is not hook up its on the starter

[terrytowe22]

That's a prob there is a engine harness ground put it on the water neck

[turbob20]

strip all paint off where the bottom radiator hose goes to block. there is a bolt hole on top next to the thermostat housing that the hose is on scrape it good and put your ground harness that runs in your main engine harness on it! this grounds your ecu and stuff!

[StarBwoy]

would it help that the car has a wire tuck but i went though the wires and there all good but ima do wat he said ^ and hit yall back

[StarBwoy]

does that harnes with the grounds on the thermostat is iy for the pump too ?

[turbob20]

does that harnes with the grounds on the thermostat is iy for the pump too ?

it grounds ecu,main relay and stuff! if the main relay doesnt work your ecu has no power either!

[turbob20]

would it help that the car has a wire tuck but i went though the wires and there all good but ima do wat he said ^ and hit yall back

if the wires were just taped and not soldered properly then thy can corrode and lose connection!