b18 into ek chasis questions

[dallasb84]

Ok, ive done enough freaking out and thinking about this issue.


With some help from some guys online (yellow_ek) and some googling . ive finally found the mounts needed for the swap.

"Driver side mount bracket- 11910-P30-000"
This piece bolts to the enine block below the cam gears. Reuse the
civic studs in this bracket. Also reuse all other civic parts at this
mount location.

"Civic SI rear upper mount- 50827-S04-N10"
Bolts directly to engine block. Use stock civic mount on chassis.

"A/C comp. bracket- 38930-P54-000"
Bolts to B series block and civic compressor. No need to discharge A/C
system during swap. Leave all A/C lines connected. Use stock civic stud
in side of A/C bracket. Also reuse STOCK CIVIC mount on chassis. Integra
piece is similar, but you must use the civic piece.

"Front tranny mount- Use b18 mount"
Use integra piece on tranny. Again, use stock civic
mount on chassis (like A/C bracket).

"Upper tranny mount- "
use all civic pieces."

Between the d series mounts and the b series mounts these should all work together to bolt in the b18.

I believe the a/c mount ive listed is for the del/sol motor since it uses the d series a/c compressor.

Thanks guys ill update with photos when the parts arrive.

Total part cost was 224.71