Results 1 to 29 of 29

Thread: Car picks up slow

  1. #1
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default Car picks up slow

    ok so my car picks up slow in first gear until about 4 secs around 2.5k rpm. it sounds like its sorta bogging and then it picks up and every other gear is perfect.. it drives perfect besides the fact that it picks up slow when i take off. could it be the tranny? or the clutch? someone told me it could be the forward clutch.. help?

  2. #2
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    no help? =(

    wheres tech5 and no mo honda when u need em!

  3. #3
    Dead or alive WANTED's Avatar
    Join Date
    Jan 2009
    Age
    46
    Posts
    91
    Rep Power
    0

    Default

    You didn't by chance mess with your timing recently, did you? Something like that is usually a symptom of being off a tooth on you timing belt.

    If not, what else have you done recently?
    "Horsepower is no substitute for brains, fuckers."

  4. #4
    Senior Member | IA Veteran
    Join Date
    Aug 2006
    Location
    1
    Age
    36
    Posts
    6,444
    Rep Power
    32

    Default

    fuel pump/filter mayb

  5. #5
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    ^ hopefully because i get bad gas mileage also..

  6. #6
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    any other ideas?

  7. #7
    VTEC Killa!! 99' LuDe's Avatar
    Join Date
    Jan 2009
    Location
    Warner Robins,GA
    Age
    38
    Posts
    479
    Rep Power
    17

    Default

    its sounds like a fuel problem, my car acts the same if i turn my fuel pressure to low.

  8. #8
    Senior Member | IA Veteran
    Join Date
    Jul 2007
    Location
    Not on IA Anymore !!!!!
    Posts
    17,879
    Rep Power
    0

    Default

    Either, timing,tune up, fuel filter(which I doubt that), stopped up cat!

    Check your tune up, timing first, BTW does it seems to be fine once you get up an moving along? or gets worse when it gets hot (car temp gauge is in the warm) Not the car running hot!

  9. #9
    Senior Member G.C's Avatar
    Join Date
    Aug 2007
    Location
    Forgot
    Age
    35
    Posts
    4,781
    Rep Power
    25

    Default

    If the cat is clogged, won't it get worse as you speed up more?
    :idb:

  10. #10
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by Tech5
    Either, timing,tune up, fuel filter(which I doubt that), stopped up cat!

    Check your tune up, timing first, BTW does it seems to be fine once you get up an moving along? or gets worse when it gets hot (car temp gauge is in the warm) Not the car running hot!

    its fine when it gets warm. it is throwing a code p0301 a misfire from cylinder 1. it seems to shake alot but im pretty sure thats the misfire.. could the misfire cause it?

  11. #11
    VTEC Killa!! 99' LuDe's Avatar
    Join Date
    Jan 2009
    Location
    Warner Robins,GA
    Age
    38
    Posts
    479
    Rep Power
    17

    Default

    yeah my buddys ls was misfiring and i sware to god it felt like his car was gonna fall apart, so that could def be it.

  12. #12
    VTEC Killa!! 99' LuDe's Avatar
    Join Date
    Jan 2009
    Location
    Warner Robins,GA
    Age
    38
    Posts
    479
    Rep Power
    17

    Default

    change your plugs

  13. #13
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    ^thnx. ima do a tune up

  14. #14
    Senior Member | IA Veteran
    Join Date
    Jul 2007
    Location
    Not on IA Anymore !!!!!
    Posts
    17,879
    Rep Power
    0

    Default

    Quote Originally Posted by j0natell0
    its fine when it gets warm. it is throwing a code p0301 a misfire from cylinder 1. it seems to shake alot but im pretty sure thats the misfire.. could the misfire cause it?
    do plugs,wires,cap an rotor

  15. #15
    Stay Humble
    Join Date
    May 2007
    Location
    WV
    Age
    35
    Posts
    1,897
    Rep Power
    20

    Default

    check your oxygen sensors man. same deal happened to me. it was real slow and hesitant until around 3k and picked up. and burned hella alot of gas. so check them. is your cel on?

  16. #16
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by chaseamundo
    check your oxygen sensors man. same deal happened to me. it was real slow and hesitant until around 3k and picked up. and burned hella alot of gas. so check them. is your cel on?

    yes

  17. #17
    Stay Humble
    Join Date
    May 2007
    Location
    WV
    Age
    35
    Posts
    1,897
    Rep Power
    20

    Default

    Quote Originally Posted by j0natell0
    yes
    if your running really rich then thats what i think it is.
    go to advance auto and have them run the comp on the
    ecu and see what they say...

  18. #18
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by chaseamundo
    if your running really rich then thats what i think it is.
    go to advance auto and have them run the comp on the
    ecu and see what they say...
    it was the timing.. i fixed it. but now it throws aP0171 code System too Lean (Bank 1)

    what do i start first with this one?

  19. #19
    Stay Humble
    Join Date
    May 2007
    Location
    WV
    Age
    35
    Posts
    1,897
    Rep Power
    20

    Default

    Quote Originally Posted by j0natell0
    it was the timing.. i fixed it. but now it throws aP0171 code System too Lean (Bank 1)

    what do i start first with this one?
    yo this could be a bad mas air flow sensor or a vacuum leak down past the sensor.try cleaning your maf sensor and check your hoses for any leaks.
    also check the fuel filter and make sure its clean

  20. #20
    LS Resurrection
    Join Date
    Jan 2008
    Location
    Fulton County, Union City
    Age
    34
    Posts
    622
    Rep Power
    18

    Default

    Quote Originally Posted by Tech5
    do plugs,wires,cap an rotor
    yeahhh dats da way to go. my cousins 4 door ls had gsr plugs, wires, cap and rotors and it was misfiring like CRAZY!

  21. #21
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by chaseamundo


    yo this could be a bad mas air flow sensor or a vacuum leak down past the sensor.try cleaning your maf sensor and check your hoses for any leaks.
    also check the fuel filter and make sure its clean

    i heard it could also be the o2 sensor.. i remember i saw the upstream one and it was bad. and i think my fuel filter needs to be changed also. ima check for any leaks today but i dont think i have any vacuum leaks.

  22. #22
    Stay Humble
    Join Date
    May 2007
    Location
    WV
    Age
    35
    Posts
    1,897
    Rep Power
    20

    Default

    Quote Originally Posted by j0natell0
    i heard it could also be the o2 sensor.. i remember i saw the upstream one and it was bad. and i think my fuel filter needs to be changed also. ima check for any leaks today but i dont think i have any vacuum leaks.

    hell yea, check the 02 sensor for sure.....

  23. #23
    IA Member
    Join Date
    Aug 2006
    Location
    forest park
    Age
    40
    Posts
    60
    Rep Power
    20

    Default

    i fixedd it fag

    Quote Originally Posted by j0natell0
    it was the timing.. i fixed it. but now it throws aP0171 code System too Lean (Bank 1)

    what do i start first with this one?

  24. #24
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by monkeyazzboi
    i fixedd it fag
    big ups to ur uncle too. haha

  25. #25
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    hey i got a 96 civic ex thats b20 swapped with a itr tranny. my CEL been's on and i checked it today and its throwing 6 codes!!!! wtf!!! i need to get my emissions done so i can get my tag asap!!


    the codes are

    p0170 Fuel Trim Malfunction (Bank 1)
    p0171 System Too Lean (Bank 1)
    p0301 Cylinder #1 Misfire Detected
    p1457 Leak in EVAP
    p1457 Leak in EVAP
    p1399 Multiple random misfire

    help me out importatlanta!!!
    Last edited by j0natell0; 01-16-2009 at 11:38 AM.

  26. #26
    Stay Humble
    Join Date
    May 2007
    Location
    WV
    Age
    35
    Posts
    1,897
    Rep Power
    20

    Default

    ok, heres what you do, look them all up.....
    thats it man....
    then let us know what they say
    then we can further assist if needed

  27. #27
    IA Member
    Join Date
    Aug 2006
    Location
    forest park
    Age
    40
    Posts
    60
    Rep Power
    20

    Default

    haha wtf..buy a new car


    Quote Originally Posted by j0natell0
    hey i got a 96 civic ex thats b20 swapped with a itr tranny. my CEL been's on and i checked it today and its throwing 6 codes!!!! wtf!!! i need to get my emissions done so i can get my tag asap!!


    the codes are

    p0170
    p0171
    p0301
    p1457
    p1457
    p1399

    help me out importatlanta!!!

  28. #28
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by chaseamundo
    ok, heres what you do, look them all up.....
    thats it man....
    then let us know what they say
    then we can further assist if needed

    haha dont think u understand what i meant. lemme edit last post

  29. #29
    Senior Member
    Join Date
    Nov 2007
    Location
    southside ATL
    Age
    37
    Posts
    1,860
    Rep Power
    20

    Default

    Quote Originally Posted by monkeyazzboi
    haha wtf..buy a new car
    haha, aiite. ima buy a dirty DA

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
ImportAtlanta is a community of gearheads and car enthusiasts. It does not matter what kind of car or bike you drive, IA is an open community for any gearhead. Whether you're looking for advice on a performance build or posting your wheels for sale, you're welcome here!
Announcement
Welcome back to ImportAtlanta. We are currently undergoing many changes, so please report any issues you encounter with the site using the 'Contact Us' button below. Thank you!