Wiring harness. Think it will work

[FasTech]

Alright, picked up a 89 honda prelude Si about 6 months ago, didn't have a trans or a title, so I figured I'd use it for parts. Got another one from SkInNy, which was an 88 S, meaning it was carb'd. The motor was shot but the trans was good and the car is clean. So I swapped the motor out of the Si and started scraping everything I needed to do a carb'd to fuel injection swap on the 88. Well everything was good until wiring harness off the 89 Si. Whoever screwed around with the car before I got it they hacked on it and now theres cut wires all over the place. Their color coated so matching them is not a problem, its do you think it will work right if their twisted back together and taped? Its the only thing disabling my car right now, and I found another one from Albany Auto Salvage for $200, but I'd rather keep my money if this would work, didn't know if any of you had ever done this.

[1flysi]

I would solder them. It isn't that hard

[FasTech]

Yea I've done that before, didn't think of that

[southside]

yea solder is better.And it should work fine.