serious problem

Printable View

Show 100 post(s) from this thread on one page

02-22-2007, 09:50 PM
jmmx258

Yeah, I have a set of Allen sockets. the EZ out has a 3/8" head on it So I put my 10mm allen socket on it backwards, then with a 6pt 10mm socket on a half inch Ratchet, I twisted the allen wrench side. The plug didnt budge!!

Its fuckin crazy!! I've never dealt with a plug so tight. We tried heating it up too!! Plus that freeze spray shit on the plug its self should've contracted the plug enough in the heated aluminum to come out. Still nothing. Might have to be drilled and helicoiled, or drilled, welded machined, and re tapped.
02-23-2007, 09:29 AM
Killer

Quote:

Originally Posted by jmmx258

Yeah, I have a set of Allen sockets. the EZ out has a 3/8" head on it So I put my 10mm allen socket on it backwards, then with a 6pt 10mm socket on a half inch Ratchet, I twisted the allen wrench side. The plug didnt budge!!

Its fuckin crazy!! I've never dealt with a plug so tight. We tried heating it up too!! Plus that freeze spray shit on the plug its self should've contracted the plug enough in the heated aluminum to come out. Still nothing. Might have to be drilled and helicoiled, or drilled, welded machined, and re tapped.

THE HELL IT DOES!!! i got a new head this morning.... getting ready to start work again!
02-23-2007, 09:30 AM
Killer

ah, joey... ranj is the one i was talking about yesterday.. i knew i had the wrong name...

look up his general tech thread about ur fast idle thermo valve!
02-23-2007, 09:36 AM
jmmx258

Haha Hell yah dude. You want help puttin it on again? lol
02-23-2007, 11:02 AM
Killer

if ur free i sure wouldn't mind the help!

i think i'm gonna use my cams on it.. mine look better..
02-23-2007, 11:12 AM
Sol-Badguy

Good luck with it!
02-23-2007, 11:18 AM
Killer

thanks man.. i'll prolly piss my panties when it's running again!!!!! lol...
02-23-2007, 11:22 AM
jmmx258

Quote:

Originally Posted by Killer

thanks man.. i'll prolly piss my panties when it's running again!!!!! lol...

I dont think I woulda said panties haha!! O'well Off to autozone Good luck. If i get my shit straightened out i'll come down and lend a hand
02-23-2007, 04:09 PM
Killer

how did everything work for u???? i'm like minutes from being done.. i just gotta figure out my distributer and the wires.... I NEED SOME HELP PEOPLE!
02-23-2007, 05:22 PM
Killer

the car won't crank! not even turn over at all...

something electrical is keeping it from cranking...

do either of the wires that connect to the throttle body and the idle air control valve keep it from starting?

and i need a crips clear picture of the distributor.. i need to know which plug wires go where...

Show 100 post(s) from this thread on one page