Its a real black on black on black Cobra convertible and have documentation and proof from MV performance that the car is everything listed.
I may be leaving some things out but this is all I can think of at the moment. The original car has 130,xxx miles but as you can see nothing is stock really anymore. When the motor was built a new starter, alternator, belt tensioner, coolant sensors, mass air, knock sensor, cam sensors, water hoses, one new a/c line as it had a small leak were all replaced as well.This is a low compression motor as it was supposed to be a turbo car. $9,500 OBO or trades for a truck of lesser value. Thanks for looking text me please as it is easier
678-665-1675
Motor around 20,xxx miles
.30 over aluminum Teksid block
Ported 03 Cobra heads
Ported 01 Cobra intake
Mahle forged rods
Probe industrys forged positions
Eagle forged 8 bolt crank
Full k&n intake
SCT tune
SCT 3 bank chip
Egr delete
Dpfe delete
Cat delete
Secondary air pump delete
Ford racing high volume oil pump
B&M stainless oil cooler
Oil filter relocation kit
Optima red top battery
Hardened race bearings and rings
Mac long tube headers
Bassani x-pipe
Flowmaster 40 series cat back
Carbon fiber oil catch can
Transmission around 50,xxx miles
Mach 1 transmission from a 03 Mach1 T3650
Steeda Tri-ax short throw shifter
Spec stage 2 clutch about 20,xxx miles
Fully adjustable quadrant and firewall adjuster
Ford racing aluminum drive shaft
Rear end
8.8 rear axle
373 gears around 40,xxx miles
Moser 31 spline axles
Interior
Mach 1 front seats
Modified to fit Mach 1 rear seat
Mach 1 silver a/c panel
Mach 1 silver shift panel with billet aluminium trim
Billet aluminum a/c knobs, headlight switch, defrost switch
Ford racing aluminum pedals
Mach 1 center console
2 gauge pod around gauge cluster
Electical
Boston Accustics component front speakers
Boston Accustics component rear speakers
Stewart Warner Oil pressure gauge
Stewart Warner Fuel air mixture gauge
Alpine 550 watt amp for interior speakers
Sequential turn signals
Kenwood head unit with iPod cable running to glove box
8000k HIDs
Suspension
Lowering springs from PO not sure brand
Motor craft front and rear struts
BBK camber/caster plates
Poly urethane sway bar bushings
03 Cobra front sway bar
QA1 tubular k-member
Mac sub frame connectors
Exterior
Full custom paint job with body line stripe that's painted and flush with the rest of the paint
Saleen 281 carbon fiber hood
Saleen 281 spoiler hydro dipped carbon fiber
Black 2 piece headlights
Custom painted coil covers to match paint job
Powder coated intake, coil brackets, timing covers, mass air flow body
10th anniversary Cobra wheels 9" front on a 245/45/17 10" rears on a 275/35/17
Cross drilled vented slotted and zinc coated front and rear rotors
04 Cobra convertible top from a garage kept Cobra that got T-boned had 32,xxx miles much nicer top being cloth over the factory vinal