green91 build thread (peer pressure made me do it)

[green91]

EDIT: build will be continued at http://www.halffastmotorsports.com under projects

Hey guys,
My EF has been an ongoing build for the 6 years that I've owned it so this wont be a ground-up build, but rather the changes its going through now. My thread probably wont be as picture intensive as slow_hatch's but ill try and snap some along the way. Ima a Master ASE technician and work at a Toyota dealer so I've got the luxury of 30k of tools and a lift to make this easier than when i first started lol.


I had the car previously turbo'd on the stock d15b2, then on a d16z6, and then swapped in the b16a. because of many reasons i was'nt happy with the b16 so i decided to do another sohc turbo setup, freshen up the motor and do some other mods. since all of my driving is mountain driving i am only looking for 200-220whp which will be easily attainable.

Car specs:

91 DX Hatch - Tahitian Green Pearl (my fav EF color)

Exterior:
Si front lip
Black hood (hit a deer, sux)
Removed yellow from bumper light markers

Engine:
d16z6 sohc vtec, 30 miles since rebuild lol.
-acl bearings
-npr rings
-arp head studs
-all new seals, mls head gasket, water pump, t-belt etc.
custom engine mounts (solid polyurethane)
mpfi conversion (redid the entire engine harness, looks stock!)
dx exhaust mani (only while breaking the engine in)
cheapo intake (only while breaking the engine in)
b&m fuel gauge
DA throttle cable
91 Si trans
ACT Extreme PP & Clutch Disc
gsp axles
polyurethane shift bushings
custom 2.25 magnaflow exhaust

suspension:
kyb agx adjustable shocks
ground control coil-overs
DA front knuckles
-Brembo blank rotors
-Hawk HP+ pads
DA trailing arms, rear disc conversion
-Brembo blank rotors
-Hawk HP+ pads
LCA polyurethane bushings
front sway bar polyurethane bushings
rear strut bar
front strut bar
rota c8's with falken ziex (junk)

interior:
new aftermarket carpet
del sol seats, green stripe
si rear seats
si center console
si gauge cluster
apexi vafc
grant steering wheel
autometer boost gauge
autometer a/f gauge

In the works!

obd1 conversion (have chipped p28, distributor, harness is in the mail)
-will be running crome
drag cast turbo manifold t3
garrett t3 .42/.48
jrc fmic
custom piping
custom oil line kit
450cc injectors
other misc ****

I'm sure theres a ton of **** im forgetting lol

Anyway onto a few pics:

removed this steaming pile of ****


rebuilt then installed this:


how she sits tonight (pic sucks!)


couple other misc pictures along the way