Clutch, Flywheel, Valvetrain and more
Ok, im looking to sell...
-Competition stage 3 clutch kit (pp, clutch, t.o. bearing, NO alignment tool, im keeping that), doesnt have that many miles on it because half the time i had the clutch, my car was under construction. I would say low-mid amount of mileage.
-Clutchmasters 7-8?lb flywheel, like new also.... newer than the clutch.
-Skunk2 springs and retainers with ferrea locks
-ferrea pro-comp valves: 12 - 1mm over intake, 12 - .5mm over exhaust (ill let these go for really cheap since the faces have a little damgage from the 1 valve dropping.
-2 vtec solendoids: 1 is missing the vtec sensor, one is perfect.
-Messed up b16a head, mike at mainstream said it could be repaired... let go for really cheap.
-2000 Si steering wheel with airbag
-Turbonetics boost controller - 35psi max
I think there is more, but this is a good start. I should have plenty of vouches on here. I will also try to get pictures up as soon as possible.. but im lazy so it may take a minute.
Now, for pricing...... I DONT CARE!!! i will probably sell most of this for half of what i could get for it, but i dont care, its in the way i want it gone. BUT, please make a reasonable offer, cause i am a pretty patient dude and will wait for a decent offer. The things that i will do for the cheapest are the clutch, because im not sure of the mileage, the head, cause it needs repairing, valves, and boost controller.
The story behind the head is that the shop didnt allow for enough clearance in between the guide and valve so the valve siezed and fell into the cylinder. So basically everything on the top of the head is in perfect condition.
So let the buying begin!
p.s. if im missing any required information, let me know and i will post that up a.s.a.p.
Reply With Quote
