I want to make my F22B1 faster but not spending a fortune any suggestions, I already have a 4-2-1 header, a cat-back exhaust, aem v2 intake so what else besides these basics would do
F22b1
I want to make my F22B1 faster but not spending a fortune any suggestions, I already have a 4-2-1 header, a cat-back exhaust, aem v2 intake so what else besides these basics would do
put a nitrous kit on it like a 50 shot or somthing
turbo.
head work.
turbo is the best bang for your buck in my opinion. i had a turbo f22b1.
"The 1911 is a collection of subsystems that must work together. Each part must be prepared and fit properly not only in and of itself, but also with regard to the other parts with which it must operate for the gun to function and appear as desired."
F22 wont be fast for all motor unless you spend tons of money. if you want it to go fast while not spending alot of money, id say go turbo. With nitrous it'll be decent but still not too fast unless you unload alot of nitrous into your engine.
Either that or drop in a H22
94 Supra= 500rwhp
Well you can get a camshaft regrind. Look at www.webcamshafts.com. There not too bad. Its probably going to get you similiar gains to a i/h/e.
92 Prelude Si
Milano Red H23a1
I have the non-vtec version of your motor and with c.a.i. and a weapon-r throttle rotor i noticed a decent improvement. Also you should consider the most important thing we rice-burners have against dem v-8's, weight. I tossed my spare tire, rear seats (top and bottom) and I try to run no more than half a tank of gas in my car and that totaled about 100lbs. And thats not goin all out and completely stripping your car and having to deal with the extreme interior noise. Just some thoughts. good luck.
H22's run $1,800-2,500 with transmission, plus labor, or you can do a turbo for a little less than that.
Posting Permissions
Reply With Quote
