B18b w/ JRSC @ 8psi, have been breaking in motor on base map CROME ECU for 300 miles running non-synthetic 10w-40. Going on dyno for tune in couple weeks, should i tune it on current oil, or switch to my castrol syntec 5w-20?
B18b w/ JRSC @ 8psi, have been breaking in motor on base map CROME ECU for 300 miles running non-synthetic 10w-40. Going on dyno for tune in couple weeks, should i tune it on current oil, or switch to my castrol syntec 5w-20?
only swap to synthetic after 1500miles.
I did something very similar to this.... i changed my oil a day before going to the dyno with non-synthetic. Its just in good-measure, plus you can probably make 1-2 more whp with fresh oil vs. old oil.
Def change it at 500 mile mark to Fully synthetic. Thats the perfect engine break in period. When i built my RB I waited until 804 Kilometers later (500 miles) Then switched to Eneos full synthetic. Everything was completely fine. As far as for the Dyno day. if your at the 500 mark, Change it. If not dont worry about it. You will only loose maybe 1 to 2 HP.
just make sure ur topped off before the dyno
3000 miles before syn... i would really do 5k no need to switch early. motor can still be broken in 1500 miles. i have had a few poeple with 1400 and the motor was still very weak. had to be rebuilt and rehoned because of syn being used to early.
ever get your tested i bet you can go a lot farther than 6k if you have the right oil.
The G Spot Hero
"Nitrous is like a hot girl with STDS, you know you want to hit it but your afraid of the consequences."
weird. oh well too late for me now lol
5w20 to thin atleast 5w30 minimum i use rotella 15w40 in my freshly built motor it cleans it and runs good cant go wrong
I recommend using oil when you change your oil.
oil changes every 500 miles for the first 1500 miles. go regular oil at least until the 1500 mile mark or the oil change after.
MAINSTREAM PERFORMANCE & DIGITAL BOX TUNING
ECU CHIPPING/SOCKETING/TUNING-HONDATA, CROME, BRE, TURBOEDIT
HONDATA DEALER/TUNER
NISSAN REALTIME-NISTUNE
MITSUBISHI AND SUBARU TUNING AVAILABLE!
for my first built b18c (pistons/rods) i changed the oil at 100 miles, 500, 1000, then 1500 with regular 5w-30 oil. then you can change again at 3k miles with synthetic and keep using it from then on. i wouldn't go 6k miles between oil changes on a boosted motor...stick with 3-4k between changes to be safe.
and i think 5w-20 is too light...if you rebuilt the motor with oem parts i'd say stick to what honda recommends, 5w-30 or 10w-30. for built motors some ppl like to go thicker. i've tried a bunch of weights and personally like 5w-40 (i use it in my 1.8t audi and in the teg during the winter) and 5w-50 the best.
The G Spot Hero
"Nitrous is like a hot girl with STDS, you know you want to hit it but your afraid of the consequences."
ive heard the same. better made oils ftw
I have a built B18c 5 years strong 15psi street 28psi race and only use 10 40 regular valvoline plus zddp additive...No problems, i change my oil as soon as it turns black!!! Fresh oil before and after dyno runs always.oh i forgot get genuine Honda S2000 oil filter for better oil pressure.
i've never personally done it but i've read up a good bit on the subject (mostly on bobistheoilguy.com) and experimented with lots of oil weights and brands before going with what i use now. i also have friends with very similar setups (daily driven boosted hondas) do the same and get their oil tested and we've discussed the results. this is my 2nd boosted honda and it's been almost 4 yrs and damn near 70k daily-driven miles on this particular motor...it sees full boost almost every day and it is still running strong. so i do know a LITTLE about what i am talking about
i know what trying to get at and you're mostly right...now i'm not a mechanic but i am speaking from my personal experience. maybe my mind is playing tricks on me but honestly i can usually notice a difference (even if it's slight) in my car's performance after i've run the oil for 3k or so miles. i know when it's time for a change without even having to check the odometer.
thank you for not just posting blah blah blah... but actually what YOU have done and not hearsay. but i do have to say something about your so called power loss. oil become THINNER with use, not thicker. and yes i know friction goes up with that particulates of dirt and what not in it. but the gas from blow by thins it out. hmm... i guess its kinda funny. how that works though.
true i have changed oil in 500 miles on a old motor that usually get oil changes every 3k for its whole life. and after 500 miles it was pretty much black. you cant really test it out by doing multiple oil changes right after each other with almost no run time between. just to help get out ALL the old oil. since you would have to tear down the motor to get all of it. or just do many oil change/flushes.
The G Spot Hero
"Nitrous is like a hot girl with STDS, you know you want to hit it but your afraid of the consequences."