ok i jus bought a 89 crx si and im gona put a ls b18b1 motor in it and im planning on boosting it but i want it to be able to hold about 15 to 20 psi what all should i do this motor that would make it jus enough to handle that many pounds?????????
ls turbo help
ok i jus bought a 89 crx si and im gona put a ls b18b1 motor in it and im planning on boosting it but i want it to be able to hold about 15 to 20 psi what all should i do this motor that would make it jus enough to handle that many pounds?????????
get it sleeved and get pistons,rods, and head studs...oh and the main thing a good tune
how much would all that run me??
what if i put sum aftermarket cams and valve springs and retainers how much boost could i run then?
1 million
lol to get a block sleeved its around a 1000.
heres Goinfasterthanu setup.
Ls bottom end
srp 8:5:1 pistons
eagle rods
acl bearings
Ls head {THIS HEAD FLOWS}
Fully ported { i have 1000$ just in head porting and such}
5 angle valve job
Arp head studs
Crower retainers
crower valve springs
crower stage 2 cams
msd wires and cap with coil
powder coated valve cover vented with -10 an lines and spoolin catchcan
aem fuel rail
aem cam gears
Turbo setup
Revhard mani {a/c comatable}
Garrett t3/4 turbo .60 trim
2 1/2 inch down pipe
Greddy profec b boost controller
Hks bov
Tial wastegate
Big ASS intercooler
Fluidyne rad
Fal fan
Hondata s200 with boost
how much power do you want?????
JJSPEC.COM
i was thinking about 275 300hp
hell, if you dont got arp headstuds say good bye to your block
hell you can do that on a stock block LS if its healthy. if you want to be safe do block guard/pistons/rods build.Originally Posted by joshk5145
how much psi can i push with just a built head and arp headstuds
you need to have a power goal that you want, not a psi goal...
and dont waste your money on a block guard
how much power u get out of that sohc red civic u got
how much power u get out of that sohc red civic u got
ill be happy with 220 whp
Posting Permissions
Reply With Quote
