View Full Version : Power Mods valvetrain difficulty?
brwloco
12-17-2006, 03:31 PM
just wondering how hard will it be if i put skunk2 springs and retainers plus the skunk2 cams in my B18c? and the head is not coming off and i no that i will need a valve spring compressor but overall how hard??
IntegraXTR
12-17-2006, 04:14 PM
if you've never done it before then I recommend you take it to a shop. I've helped in installation before but the head was off already, with that being said since the head is stayin on your ride then I would say 7/10 since you've never done it before. Check out bseries.net for some info.
Vteckidd
12-17-2006, 04:15 PM
very hard if you have never done it before.
the task itself is not that bad, but there is no room for error.
you will need a snap on style SPring Compressor
Air Compressor with fitting for the head, you will need to fill each cylidner with air to keep the valves up.
brwloco
12-18-2006, 09:23 PM
http://honda-tech.com/zerothread?id=1604753
is this how it should be done??
whats another way i could keep the vavles up besides using air?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.