'91 Talon

[Brick]

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519896

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519899

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519901

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519903

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519904

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519907

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519909

http://www.imagehosting.us/imagehosting/showimg.jpg/?id=519910

Got it about a month ago....but, it'll probably be up for sale around the end of this month.

[JITB]

Purty..

[sirhatch1030]

how much will you sell it for.

[Brick]

Open to offers, here's what it has.

6 bolt block bored .20 over w/ around 30k assembled by AMS
2g pistons
1g big rods
clevite 77 bearings
ARP head studs
factory head gasket
head port and polish done at time of rebuild
fresh water pump, front cover, timing belt, oil pump, and harmonic balancer
removed balance shafts
metal gaskets, new pcv valve, new brake booster
all silicon vacuum hoses
dejon tool 2g-1g intake pipe with recirc
2g mas air flow sensor
cosmo filter & 2g adapter plate
1g bov
stock 60mm intake manifold
AMS slimline fan
ported 2g exhaust manifold
PTE 50 Trim turbo, .60 A/R, stage III wheel
HKS External Wastegate
JRP 32x7x3 FMIC with short route piping
ported EVO III o2 manifold
Full 3" turbo-back exhaust with Vibrant muffler
Joe P Manual boost controller
walbro 255 pump
new fuel filter end of '04
Charged Air Systems adj. Fuel Pressure Regulator
B&M Fuel Pressure Gauge
PTE 680cc ball/disk injectors
JDM transmission w/ TRE rebuild - few thousand miles on it
-Upgraded 1/2 double synchro set
-Steel EVO III shift forks
-Steel shift rails
-Upgraded 3/4 gearset
Raxles front Axles
S-AFC 1 With Blue Wire Mod
ApexI Turbo Timer
Installed Datalogger cable
Autometer Boost guage
SS clutch line
ACT 2100 clutch with replaced TOB
resurfaced flywheel
Progress springs 1.25" drop in front 1.5" in back
KYB GR-2's
GVR-4 dual piston calipers
3000GT SL front rotors
Mitsubishi pads
NX-7 Gunmetal rims with polished lip
new Pioneer CD/XM head unit
Diamond CM3 6.5" front speakers
Polk/Momo 6x9 rear speakers
Viper Alarm

I bought it with all of that done minus the Polk speakers and Viper alarm, which I had done. I also put BG Syncroshift II in the tranny and Amsoil 75W-90 in the rear differential. Also have a Fidanza short shifter on the way. Only had it since May 6. I just need the money for some other things and I'm probably going back to the world of Turbo Buick powered cars.

[ProjectWidow]

very nice!! someday ill have a project talon.

[Julio]

Hey where can I find a Talon shell? or a talon period, DOnt care about the motor, just a decent body.

[Brick]

Hey where can I find a Talon shell? or a talon period, DOnt care about the motor, just a decent body.
ga.dsm.org
dsmtrader.com
dsmtalk.com
dsmtuners.com
4g63hp.com
dsmhorsepower.com

[SilverJester]

very nice :goodjob: what are you using to tune it? awd?

[HiPSI]

very nice :goodjob: what are you using to tune it? awd?



and Amsoil 75W-90 in the rear differential

;)

[Brick]

very nice :goodjob: what are you using to tune it? awd?

Have SAFC to tune with, going to see if I can't get Batlground to tune it around the end of the month on the dyno with wideband. Got the cable for a data logger, just need the palm to hook it up to.

[SilverJester]

If you weren't going to get rid of it I'd suggest getting something better to tune with...but I bet it can still haul some ass ;) Is battleground pretty good, I've never heard (except for on this board)? Do they have AWD dyno? My friend is taking his car to AMS to get tuned, you'd think a shop as well know for mitsus as AMS would have an AWD dyno but they don't...sucks

[Z33_kid]

nice

[Brick]

If you weren't going to get rid of it I'd suggest getting something better to tune with...but I bet it can still haul some ass ;) Is battleground pretty good, I've never heard (except for on this board)? Do they have AWD dyno? My friend is taking his car to AMS to get tuned, you'd think a shop as well know for mitsus as AMS would have an AWD dyno but they don't...sucks

Yeah, the SAFC isn't exactly my first choice in tuning tools- but it came on the car when I bought it. Batlground is a great place. AMS actually worked on this car a bit, I bought it from a guy in Chicago.

[HalfBaked]

What you gonna get if you sell it Nick?

[YokotaS13]

i wish i could rock it, dsmlink is the way to go