89 crx auto to manual?

[crx_guy]

ok i just finished the swap, and now my car is idling higher? um, i adjusted the idle screw but it only idle down a little, its at 1.5 and before the swap it was about 800-1.0 . i was told that it might have a vaccum line but there were no hoses running off of it, also i tryed the throttle cable but it would shut off if i go any lower..... any ideas guys?

[EmminoDaGreat]

did you use ur stock auto ecu>?

[crx_guy]

no, i used a manual ecu pm5 dpfi, and yes i know for a fact its a manual ecu cause it came out of my brothers car.

[crx_guy]

anything else? :thinking:

[EmminoDaGreat]

iacv, vacuum lines

[crx_guy]

ok i found the problem i had to use my auto pedal and it had rubber on the back of it, well so did the assembly, so it was raising it up and i took it off and it idles just right