SPOOLIN
12-02-2006, 09:17 PM
I have an AVID racing billet aluminum Mount kit that has been using only in a race car for about a month or 2. It allows the installation of a b series hydro setup into a 96-2000 civic. The rear mount that goes on the cross member i had to really waller out the holes to make it line up so the holes are nice and chewed up but the mount is stationary bolted to the cross member so it does not make a difference plus you cant see it with the engine in anyways. The other mounts are fine. ill sell the kit for 250$ shipped, YOU PAY 3% if you do paypal, I am paypal verified
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/Picture005kjhkj.jpg
pic of wallering out the holes on the rear mount
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/khgjkhfhPicture008.jpg
it was hard to do with a dremel and shitty bits
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/jljhkljPicture.jpg
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/Picture005kjhkj.jpg
pic of wallering out the holes on the rear mount
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/khgjkhfhPicture008.jpg
it was hard to do with a dremel and shitty bits
http://i28.photobucket.com/albums/c203/spoolinmatt/MISC/jljhkljPicture.jpg